To install Asterisk server in your computer, please consider the minimum hardware and software requirements. These are the minimum requirements.
Operating system:
If you install Asterisk please be advised that all existing da
Run this command in the console:
For CentOS 4:
For CentOS 5:
After installating the updates, you need to reboot to boot to your new kernel, just type the command below.
Then download the asterisk-1.2.26.2.tar.gz and zaptel-1.2.23.tar.gz packages from http://downloads.digium.com/ and untar all the files directly to /usr/src directory.
If you want to use Music On Hold for your PBX, run this command:
Then continue installing using the following commands.
To start asterisk run the command:
To run the asterisk console command:
You can download the open source g729 codec based on the type of your processor here: http://asterisk.hosting.lv/.
Configure ztdummy and asterisk to start automatically
To load the ztdummy driver run this following commands:
Run vi /etc/rc.local and add the following lines to automatically start ztdummy driver and asterisk.
modprobe
zaptel
modprobe ztdummy
asterisk –g
Then hit Esc key and type
Reboot your system and that’s it!!! You have now a working asterisk PBX system…
Thanks to Mark Quitoriano for a very good howto and tutorial.
Source: http://www.voip-info.org/wiki/view/Asterisk+installation+for+CentOS+4.x
评论